S3+1 bit 5 set to 1 (required to set the output upper and lower limit) Target value set to 100 and Actual value set to 10(The actual value wont change, I just wanted to get some output change in response to the PID trying to achieve 100) My first question is, is it possible to simulate this block?īelow is my current setup, I have assigned D500 to the parameter values, this uses D500-D528 to store the parameters. I am using the FXCPU Structured programming manual pages 414-417. I have the project setup for use with a FX3G PLC, I am unable to get any form of output from the block when setting it up. Hello, I am trying to simulate the PID block in GX Works2.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |